Configuring client information backup – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 753
732
Figure 760 Configuring 1+N AC backup
4.
Configure 1+N backup as described in
.
5.
Click Apply.
Table 243 Configuration items
Item Description
Backup AC IPv4 Address
Set the IPv4 address of the
backup AC.
If the global backup AC is also configured on
the page you enter by selecting Advanced > AC
Backup, the configuration on this page is used
first.
Backup AC IPv6 Address
Set the IPv6 address of the
backup AC.
Configuring client information backup
Before performing this task, establish an IACTP tunnel (see "Configuring WLAN roaming") and
configure AC backup (see
) on the two ACs.
By default, client information backup is disabled. H3C recommends that you enable client information
backup after the configuration of 1+1 AC backup and IACTP tunnel. 1+1 AC backup takes effect only if
client information backup is enabled on both ACs.