H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 272)

251
Configuring the PPPoE client
1. Configure the PPPoE client:
a. Select Network > PPPoE from the navigation tree.
The system automatically enters the Client page.
b. Click Add.
The page for creating a PPPoE client appears, as shown in
Figure 227 .
c. Enter 1 as the dialer interface name.
d. Enter user1 as the username.
e. Enter hello as the password.
f. Select PPP Negotiate for IP config.
g. Select Vlan-interface1 for Bundled Interface.
h. Select Always Online for Session Type.
i. Click Apply.
Figure 227 Creating a PPPoE client
2. Configure the PPPoE server:
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and
password that are the same as those configured on the PPPoE client, and assign an IP address to
the peer end of the PPP connection. (Details not shown.)
Verifying the configuration
To display the summary information of the PPPoE session on an AC: