H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 29)

8
Module Feature WX5002V2 WX5004
Security Session management Yes. Yes.
Advanced
settings
AC hot backup Yes. Yes.
1+1 fast backup (Hello interval)
Yes. (The hello interval is in
the range of 100 to 2000
and defaults to 2000.)
Yes. (The hello interval is in
the range of 100 to 2000
and defaults to 2000.)
Wireless location Yes. Yes.
Wireless sniffer Yes. Yes.
BAS AC Yes. Yes.
Multicast optimization Yes. Yes.
Guest access tunnel Yes. Yes.
Bonjour gateway Yes. Yes.
Hotspot 2.0 Yes. Yes.
High
availability
Stateful failover Yes. Yes.
VPN VPN Yes. Yes.
SSL VPN SSL VPN No. No.
Feature matrix for the WX6000 series
The WX6103 adopts the OAA architecture. The switch interface board of the WX 6103 works as an OAP
card and is installed on the slot with purple paint at slot sides. The WX6103 supports EWPX1WCMD0
main control boards. The switch interface board exchanges data, and state and control information with
the main control board through internal interfaces. H3C recommends not configuring services such as
QoS rate limiting and 802.1X authentication on the internal interfaces.
For configuration information about the switch interface board of the WX6103, see H3C WX6103
Access Controller Switch Interface Board Configuration Guide and H3C WX6103 Access Controller
Switch Interface Board Command Reference.
The LSQM1WCMD0, LSRM1WCM3A1, LSUM3WCMD0, EWPXM1WCME0, and LSUM1WCME0 of
the WX6000 series are OAP cards. Each OAP card is installed on the expansion slot of the switch and
exchanges data and status and control information with the switch through internal interfaces. Do not
configure services such as QoS rate limiting and 802.1X authentication on the internal interfaces.
Table 4 Feature matrix for the WX6000 series
Module Feature
WX61
03
LSQM1W
CMD0
LSRM1WC
M3A1
LSUM3W
CMD0
EWPXM1
WCME0
LSUM1W
CME0
Device
License
manag
ement
License
manag
ement
No. No. No. No. No. No.