Configuring snmp trap function – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 160
139
Item Description
Group Name
Select an SNMP group to which the user belongs.
•
When the security level is NoAuth/NoPriv, you can select an SNMP
group with no authentication no privacy.
•
When the security level is Auth/NoPriv, you can select an SNMP
group with no authentication no privacy or authentication without
privacy.
•
When the security level is Auth/Priv, you can select an SNMP group of
any security level.
Authentication Mode
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Authentication Password
Set the authentication password when the security level is Auth/NoPriv or
Auth/Priv.
The confirm authentication password must be the same as the
authentication password.
Confirm Authentication Password
Privacy Mode
Select a privacy mode (including DES56, AES128, and 3DES) when the
security level is Auth/Priv.
Privacy Password
Set the privacy password when the security level is Auth/Priv.
The confirm privacy password must be the same as the privacy password.
Confirm Privacy Password
ACL
Associate a basic ACL with the user to restrict the source IP address of
SNMP packets. You can configure to allow or prohibit SNMP packets
with a specific source IP address to allow or prohibit the specified NMS
to access the agent by using name of the associated user.
Configuring SNMP trap function
1.
Select Device > SNMP from the navigation tree.
2.
Click the Trap tab.
The trap configuration page appears.
Figure 98 Traps configuration