Client access control, Configuring an ap, Creating an ap – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 322
301
When you delete an AP from an AP group (equal to adding the AP to the default AP group) or add an
AP to an AP group, the AP restarts, and clears its configuration except the serial number. After the AP is
added to the new AP group, the AP uses the configuration of the new AP group.
The following operations might fail on some member APs:
•
Select 5 GHz wireless services.
•
Select 2.4 GHz wireless services.
•
Enable a 5 GHz radio.
•
Enable a 2.4 GHz radio.
•
Set a working mode.
•
Set a country/region code.
Client access control
Some wireless service providers need to control the access positions of clients. For example, as shown
, to meet security or billing needs, it is required to connect wireless clients 1 and 2 to the wired
network through AP 1 or AP 2, and connect client 3 through AP 3. To achieve this, you can configure the
AP groups that the clients can be associated with and then apply the AP groups in a user profile. For more
information about user profile, see "
Figure 285 Client access control
Configuring an AP
Creating an AP
1.
Select AP > AP Setup from the navigation tree.
2.
Click Add.
AC
AP 1
RADIUS server
Internet
AP 2
Client 1
Client 2
Client 3
AP 3