H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 694)

673
Item Description
CIR Set the committed information rate (CIR), the average traffic rate.
CBS
Set the committed burst size (CBS), number of bits that can be sent
in each interval.
Red
Discard Set the action to perform for exceeding packets.
After selecting the Red option, you can select one of the following
options:
• Discard—Drops the exceeding packet.
• Pass—Permits the exceeding packet to pass through.
• Remark DSCP Pass—Sets a DSCP value for the exceeding
packet and then sends it.
Pass
Remark
IP Precedence
Configure the action of marking IP precedence for packets.
Select the IP Precedence option and then select the IP precedence
value to be marked for packets in the following list. Select Not Set to
cancel the action of marking IP precedence.
TIP:
This configuration item is not supported.
Dot1p
Configure the action of marking 802.1p precedence for packets.
Select the Dot1p option and then select the 802.1p precedence
value to be marked for packets in the following list. Select Not Set to
cancel the action of marking 802.1p precedence.
Local Precedence
Configure the action of marking local precedence for packets.
Select the Local Precedence option and then select the local
precedence value to be marked for packets in the following list.
Select Not Set to cancel the action of marking local precedence.
DSCP
Configure the action of marking DSCP values for packets.
Select the DSCP option and then select the DSCP value to be marked
for packets in the following list. Select Not Set to cancel the action of
marking DSCP values.
TIP:
This configuration item is not supported.
Queue
EF
Max Bandwidth
Configure the maximum bandwidth for
Expedited Forwarding (EF).
TIP:
These
configuration
items are not
supported.
CBS Configure the CBS for EF.
Percent
Configure the percent of available bandwidth
for EF.
CBS-Ratio Configure the ratio of CBS to CIR for EF.
AF
Min Bandwidth
Configure the minimum guaranteed bandwidth
for Assured Forwarding (AF).
Percent
Configure the percent of available bandwidth
for AF.
WFQ
Configure WFQ for the default class by
entering the total number of fair queues, which
must be the power of two.