H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 526)

505
Item Description
Device Types to Detect
Specify the device types to detect.
• To add a device type to the Device Types area, select a device type in the
Device Types to Detect area, and click <<.
• To remove a device type from the Device Types area, select a device type in
this area, and click >>.
By default, all device types in the Device Types to Detect area are detected.
Configuring event-driven RRM
This function enables the AC to start calculating the channel quality, and switch to a new channel with a
higher quality when the channel quality is lower than the sensitivity level.
Table 164 Configuration items
Item Description
Event Driven RRM
• Enable—Enable event-driven RRM.
• Disable—Disable event-driven RRM.
By default, spectrum analysis does not trigger channel adjustment.
Sensitivity Threshold
• High—Specify the high sensitivity threshold.
• Low—Specify the low sensitivity threshold.
• Medium—Specify the medium sensitivity threshold.
By default, the sensitivity threshold is medium.
Enabling SNMP traps
This function enables the AC to send SNMP traps to the NMS when detecting an interference device or
when detecting the channel quality is lower than the alarm threshold.
Table 165 Configuration items
Item Description
Configure channel quality trap
Channel Quality Trap
• Enable—The AC sends SNMP traps to the NMS when the channel quality is
lower than the threshold.
• Disable—The AC does not send SNMP traps to the NMS when the channel
quality is lower than the threshold.
By default, the AC sends SNMP traps to the NMS when the channel quality is
lower than the threshold.
Trap Threshold Channel quality trap threshold.
Configure interference device trap
Interference Trap
• Enable—The AC sends SNMP traps to the NMS when an interference device is
detected.
• Disable—The AC does not send SNMP traps to the NMS when an interference
device is detected.
By default, the AC sends SNMP traps to the NMS when an interference device is
detected.