Auto-ap authentication configuration example, Network requirements, Configuring the ac – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 347
Advertising
326
Figure 313 Viewing the online clients
Auto-AP authentication configuration example
Network requirements
As shown in
, enable the auto-AP function, and configure auto-AP authentication on the AC to
permit AP 1 and deny AP 2. Use the DHCP server to assign IP addresses to authenticated APs. Use the
RADIUS server to authenticate the unauthenticated AP (AP 3 in this example).
The serial IDs of AP 1, AP 2, and AP 3 are 210235A42QB095000761, 210235A42QB095000762, and
210235A42QB095000763, respectively.
Figure 314 Network diagram
Configuring the AC
1.
Create ACL 202:
a.
Select QoS > ACL IPv4 from the navigation tree.
b.
Click Add.
c.
Type ACL ID 202.
d.
Click Apply.
Advertising
This manual is related to the following products: