H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 476)

455
Figure 490 Enabling radio
Verifying the configuration
• The mesh link between the MAP and the MPP has been established, and they can ping each other.
• After 802.11n(2.4GHz) is configured on the MAP, the client can access the network through the
mesh link.
Subway WLAN mesh configuration example
Network requirements
• As shown in Figure 212 , all rail MPs are connected to an AC.
• Configure WLAN mesh so that the train MP can form links with rail MPs during movement.
Subway WLAN mesh configuration is basically the same as normal WLAN mesh configuration. Follow
these guidelines when configuring subway WLAN mesh:
1. Create a rail AP mesh policy:
Disable the link initiation function. For more information, see " Configuring a mesh policy ."
Enable mesh portal service. For more information, see " Enabling mesh portal service ."
2. Create a train AP mesh policy.
Enable MLSP.
Configure MLSP proxy VLAN information and MAC address.
Disable Role as authenticator. For more information, see " Configuring a mesh policy ."
Set the value of maximum links that an MP can form in a mesh network (the default value is 2.).
For more information, see "
Configuring a mesh policy ."