Configuring the ac, Create an map and mpp, Create a mesh service – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 473
452
Configuring the AC
1.
Create an MAP and MPP:
a.
Select AP> AP Setup from the navigation tree.
b.
Click Add.
c.
On the page that appears, set the AP name to map, select the AP model WA3628i-AGN, select
Manual from the Serial ID list, enter the AP serial ID, and click Apply.
Figure 483 Configuring an AP
d.
Configure MPP by following the same steps.
2.
Create a mesh service:
a.
Select Wireless Service > Mesh Service from the navigation tree.
b.
Click the Mesh Service tab.
c.
Click Add.
d.
On the page that appears, set the mesh service name to outdoor and click Apply.
After completing mesh service configuration, you enter the page shown in
Figure 484 Creating a mesh service
Figure 485 Configuring a pre-shared key
e.
Select Pass Phrase, and set the pre-shared key to 12345678.
f.
Click Apply.