H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 475)

454
Figure 488 Configuring mesh portal service
7. Configure the same working channel and enable the radio on the MAP and MPP:
a. Select Radio > Radio from the navigation tree.
b. Click the icon for the target MAP.
Figure 489 Configuring the working channel
c. Select the channel 153 to be used from the Channel list.
d. Click Apply.
You can follow this step to configure the working channel for the MPP. The working channel of
the radio on the MPP must be the same as the working channel of the radio on the MAP.
8. Enable radio:
a. Select Radio > Radio from the navigation tree.
b. Select the radio modes to be enabled for the MAP and MPP.
c. Click Enable.