Recommended configuration procedure, Configuring a load balancing mode – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 757
736
•
The target APs are associated with the same AC.
•
The clients can find the APs.
•
The fast association function is disabled. By default, the fast association function is disabled. For
more information about fast association, see "
Recommended configuration procedure
Task Remarks
1. Configuring a load balancing mode
Required.
2. Configuring group-based load
Required.
H3C recommends that you complete
first. A load balancing group takes effect only
when a load balancing mode is configured.
3. Configuring parameters that affect
Optional.
This configuration takes effect for both AP-based load balancing
and radio group-based load balancing.
Configuring a load balancing mode
If the AC has a load balancing mode configured but does not have any load balancing groups created,
it uses AP-based load balancing by default.
1.
Configure session-mode load balancing:
a.
Select Advanced > Load Balance from the navigation tree.
b.
Select Session from the Load Balance Mode list.
c.
Click Apply.
Figure 767 Setting session-mode load balancing