H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 531)

510
3. Perform manual channel adjustment:
a. Select Radio > Calibration from the navigation tree.
b. On the Operation tab, select the box of the target radio.
c. Click Channel Optimize.
Figure 543 Performing manual channel adjustment
Verifying the configuration
• You can view the channel status on the Operation tab you enter by selecting Radio > Calibration
from the navigation tree.
• After you perform manual channel calibration, the AC informs the adjusted channel to the AP after
a calibration interval.
• You can view the detailed information, such as the specific reason for channel adjustment on the
History Info tab you enter by selecting Radio > Calibration from the navigation tree, clicking
Operation, and then clicking History Info.
Automatic power adjustment configuration
example
Network requirements
As shown in Figure 265 , AP 1 through AP 3 are connected to the AC. Configure automatic power
adjustment and specify the adjacency factor as 3 on the AC. In this way, when AP 4 joins, the AC
performs automatic power adjustment to avoid interference.