Configuring the wireless service, Configuring static rate limiting, Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 727: Network requirements
706
Configuring the wireless service
For the configuration procedure, see "
Configuring static rate limiting
1.
Select QoS > Wireless QoS from the navigation tree.
2.
Click Client Rate Limit.
3.
Select Inbound from the Direction list, and click
.
4.
Configure static rate limiting:
a.
Select Static from the Mode list.
b.
Enter 1024 in the Per-Client Rate field.
5.
Click Apply.
Figure 736 Configuring static rate limiting
Verifying the configuration
1.
Client 1 and Client 2 access the WLAN through the SSID named service1.
2.
Verify that traffic from Client 1 is rate limited to around 1024 kbps, so is traffic from Client 2.
Wireless service-based dynamic rate limiting
configuration example
Network requirements
As shown in
, wireless clients access the WLAN through a SSID named service2.
Configure all wireless clients to share 8000 kbps of bandwidth in any direction.