H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 156)

135
Adding rules to an SNMP view
1. Select Device > SNMP from the navigation tree.
2. Click the View tab.
The page in
Figure 91 appears.
3. Click the icon of the target view.
The Add rule for the view ViewDefault window appears.
Figure 91 Adding rules to an SNMP view
4. Configure the parameters as described in Table 54 .
5. Click Apply.
NOTE:
You can modify the rules of a view in the page you enter by clicking the icon of that view.
Configuring an SNMP community
1. Select Device > SNMP from the navigation tree.
2. Click the Community tab.
The community tab page appears.
Figure 92 Configuring an SNMP community
3. Click Add.
The Add SNMP Community page appears.