H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 469)

448
Enabling radio
1. Select Radio > Radio from the navigation tree.
Figure 476 Enabling a radio
2. Select the radio mode to be enabled.
3. Click Enable.
Configuring a peer MAC address
1. Select Wireless Service > Mesh Service from the navigation tree.
2. Click .
3. Select the AP radio to be bound, and click the icon.
Figure 477 Configuring a peer MAC address
4. Configure the peer MAC address as described in Table 143 .
5. Click Apply.
Table 143 Configuration items
Item Description
Peer MAC Address
The mesh feature supports three topologies. For more information, see " Mesh
network topologies ." The mesh feature is implemented through configuration of
peer MAC addresses for each AP.
cos
Sets the STP cost of the mesh link to the peer. If not configured, the STP cost is
automatically calculated by STP.
You can view the cost of the mesh link on the page shown in
Figure 198 .