H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 289)

268
TIP:
You can click the ID link of an ACL to view details about the ACL, and create and delete ACL rules. For
more information about ACL configuration, see "Configuring ACLs."
2. In the Address Pool area, click Add.
The Add NAT Address Pool page appears.
Figure 241 Adding a NAT address pool
3. Create an IP address pool, as described in Table 98 .
4. Click Apply.
Table 98 Configuration items
Item Description
Index Specify the index of an address pool.
Start IP Address Specify the start IP address of the address pool.
End IP Address
Specify the end IP address of the address pool.
The end IP address must be identical to or higher than the start IP address.
Low priority
Configure the address pool as a low-priority or a non low-priority address pool.
IMPORTANT:
This configuration item is applicable for asymmetric-path stateful failover only. The low
priority settings for the local and peer devices must be different.
Configuring dynamic NAT
1. From the navigation tree, select Network > NAT.
The Dynamic NAT page appears.
2. In the Dynamic NAT area, click Add.
The Add Dynamic NAT page appears.