H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 682)

661
Figure 692 Configuring rate limit on a port
3. Configure rate limit, as described in Table 217 .
4. Click Apply.
Table 217 Configuration items
Item Description
Please select an interface type
Select the types of interfaces to be configured with rate limit.
The interface types available for selection depend on your device model.
Rate Limit Select Enable or Disable to enable or disable rate limit on the specified port.
Direction
Select a direction to which the rate limit is to be applied:
• Inbound—Limits the rate of packets received by the specified port.
• Outbound—Limits the rate of packets sent by the specified port.
CIR Set the committed information rate (CIR), the average traffic rate.
CBS
Set the committed burst size (CBS), number of bits that can be sent in each
interval.
EBS
Set the excess burst size (EBS).
This configuration item is not supported.
Please select port(s)
Specify the ports to be configured with rate limit.
Click the ports to be configured with rate limit in the port list. You can select
one or more ports.