H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 852)

831
Figure 886 Adding an IKE peer
4. Configure the IKE peer parameters, as described in Table 272 .
5. Click Apply.
Table 272 Configuration items
Item Description
Peer Name Enter a name for the IKE peer.
IKE Negotiation Mode
Select the IKE negotiation mode in phase 1, which can be Main or Aggressive.
IMPORTANT:
• If you configure one end of an IPsec tunnel to obtain an IP address
dynamically, the IKE negotiation mode must be Aggressive. In this case, SAs
can be established as long as the username and password are correct.
• The specified negotiated mode is used when the local peer is the negotiation
initiator. When acting as the responder, the negotiation mode of the initiator
is used.