Verifying the configuration, Ap version upgrade configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 806
785
3.
Configure a load balancing group:
a.
Select Advanced > Load Balance from the navigation tree.
b.
Click the Load Balance Group tab.
c.
Click Add.
d.
On the page that appears, select ap1. radio 2 and ap2. radio 2 in the Radios Available area,
click << to add them to the Radios Selected area, and click Apply.
Figure 820 Configuring a load balancing group
Verifying the configuration
•
Radio 2 of AP 1 and radio 2 of AP 2 are in the same load balancing group, and the radio of AP
3 does not belong to any load balancing groups. Because load balancing takes effect only on
radios in a load balancing group, AP 3 does not take part in load balancing.
•
Assume Client 3 wants to associate with AP 1. Because the maximum traffic threshold and traffic
gap have been reached on radio 2 of AP 1, Client 3 is associated with AP 2.
AP version upgrade configuration example
Network requirements
As shown in
, configure the AP version upgrade function to upgrade the AC, AP 1 and AP 2.
The AC has established an LWAPP tunnel with AP 1, AP 2 and AP 3, respectively.