H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 750)

729
Configuring 1+1 AC backup
1. Select Advanced > AC Backup from the navigation tree.
Figure 758 Configuring AC backup
2. Configure an IP address for the backup AC as described in Table 240 .
3. Click Apply.
Table 240 Configuration items
Item Description
IPv4
Enter the IPv4 address of the
backup AC.
If the backup AC is configured on the page you enter by
selecting AP > AP Setup, the configuration on this page is
used first. For more information, see " Configuring APs ."
The access mode configuration on the two ACs must be
the same.
Specify the IP address of one AC on the other AC in an
AC backup.
Support for AC backup varies with the device model. For
more information, see "About the H3C Access
Controllers Web Configuration Guide."
IPv6
Enter the IPv6 address of the
backup AC.
Switch Delay Delay time for the AP to switch from the backup AC to the primary AC.
Configuring 1+1 fast backup
1. Select Advanced > AC Backup from the navigation tree to enter the page shown in Figure 479 .
2. Configure fast backup as described in Table 241 .
3. Click Apply.