Configuring a channel busy test, Figure 485 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 755
Advertising
734
Figure 764 Transmission rate (802.11ac)
3.
Click Apply.
4.
To stop the continuous transmitting mode:
Click the
icon for the target radio.
Or, select the target radio and click Stop.
After the continuous transmit is stopped, the transmission rate value on the page shown in
is displayed as 0.
NOTE:
When continuous transmit is enabled, do not perform any operations other than transmission rate
configuration.
Configuring a channel busy test
1.
Select Advanced > Channel Busy Test from the navigation tree.
Figure 765 Configuring a channel busy test
2.
Click the
icon for the target AP.
Advertising
This manual is related to the following products: