H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 810)

789
Wireless location configuration example
Network requirements
As shown in Figure 545 , AP 1, AP 2, and AP 3 operate in normal mode. They send the collected tag and
MU messages to an AE (the location server), which performs location calculation and then sends the
data to the graphics software. You can obtain the location information of the rogue AP, APs, and clients
by using maps, forms or reports.
Figure 824 Network diagram
Configuration guidelines
Before you enable the wireless location function, make sure at least three APs operate in normal mode,
bind the APs to a wireless service, and enable the wireless service so that the APs can detect Tags and
clients not associated with them, and that the AE can implement location calculation.
Configuring the AE
1. Configure the IP addresses of AP 1, AP 2, and AP 3 on the AE, or select the broadcasting mode
for the AE to discover APs.
2. Perform configuration related to wireless location on the AE.
Configuring AP 1
AP 1, AP 2, and AP 3 are configured similarly, and the following only describes how to configure AP 1
for illustration.
To bind the wireless service to AP 1:
1. Select AP > AP Setup from the navigation tree.
2. Click Add.
3. On the page that appears, enter the AP name ap1, select the model WA3628i-AGN, select
Manual from the Serial ID list, enter the AP serial ID in the field, and click Apply.
Switch
AP 2
AP 1
AP 3
Client
Rogue AP
AP
AE (location server)
AC