Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 597
Advertising
576
Figure 602 Configuring an accounting method for the ISP domain
6.
Enable the Telnet service:
a.
From the navigation tree, select Network > Service.
b.
Select Enable Telnet service.
c.
Click Apply.
Figure 603 Enabling the Telnet service
7.
At the CLI, configure the VTY user interfaces to use AAA for user access control.
<AC> system-view
[AC] user-interface vty 0 4
[AC-ui-vty0-4] authentication-mode scheme
[AC-ui-vty0-4] quit
Verifying the configuration
Telnet to the AC and enter the username hello@bbb and password abc. You can log in and access
commands of level 0 through level 3.
Advertising
This manual is related to the following products: