Ipv6 static route configuration example, Network requirements, Configuration outlines – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 215: Configuration procedure
194
IPv6 static route configuration example
Network requirements
The IP addresses of devices are shown in
. IPv6 static routes must be configured on Switch A,
Switch B and AC for Host A and Host B to communicate with each other.
Figure 164 Network diagram
Configuration outlines
1.
On Switch A, configure a default route with Switch B as the next hop.
2.
On Switch B, configure one static route with Switch A as the next hop and the other with AC as the
next hop.
3.
On AC, configure a default route with Switch B as the next hop.
Configuration procedure
1.
Configure a default route with the next hop address 4::2 on Switch A.
2.
Configure two static routes on Switch B: one with destination address 1::/64 and next hop
address 4::1, and the other with destination address 3::/64 and next hop address 5::1.
3.
Configure a default route on AC:
a.
Select Network > IPv6 Routing from the navigation tree.
b.
Click the Create tab.
The IPv6 static route configuration page appears, as shown in
c.
Enter :: for Destination IP Address, select 0 for Prefix Length, and enter 5::2 for Next Hop.
d.
Click Apply.