Link aggregation and lacp configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 250
229
Link aggregation and LACP configuration example
Network requirements
As shown in
, aggregate the ports on each device to form a link aggregation group,
balancing incoming/outgoing traffic across the member ports.
Figure 198 Network diagram
Configuration procedure
You can create a static or dynamic link aggregation group to achieve load balancing.
Method 1: Create a static link aggregation group
1.
From the navigation tree, select Network > Link Aggregation.
2.
Click Create.
3.
Configure static link aggregation group 1:
a.
Enter link aggregation interface ID 1.
b.
Select the Static (LACP Disabled) option for the aggregate interface type.
c.
Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3.
4.
Click Apply.