Configuring the wireless service, Configuring dynamic rate limiting, Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 728: N in, Figure 458
707
Figure 737 Network diagram
Configuring the wireless service
For the configuration procedure, see "
Configuring dynamic rate limiting
1.
Select QoS > Wireless QoS from the navigation tree.
2.
Click Client Rate Limit.
3.
Select service2 from the Wireless Service list, select Inbound from the Direction list, and click
.
4.
Configure dynamic rate limiting:
a.
Select Dynamic from the Mode list.
b.
Enter 8000 in the Total Rate field.
5.
Click Apply.
Figure 738 Configuring dynamic rate limiting
Verifying the configuration
Verify that:
1.
When only Client 1 accesses the WLAN through SSID service2, its traffic can pass through at a
rate as high as 8000 kbps.
2.
When both Client 1 and Client 2 access the WLAN through SSID service2, their traffic flows can
each pass through at a rate as high as 4000 kbps.