Displaying the mesh link status, Mesh link monitoring, Mesh link test – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 471
450
NOTE:
•
If you select Auto or Close for dynamic channel selection on the Global Setup tab, when you enter the
Mesh Channel Optimize page, the Channel Optimize button is grayed out, and you cannot perform
the operation.
•
If you select manual DFS on the Global Setup tab, select mesh networks where DFS will be performed,
and then click Channel Optimize to complete DFS. In auto mode, DFS is performed at the calibration
interval. In manual mode, DFS is performed one time.
Table 144 Field description
Field Description
AP
AP name in the mesh network.
Radio
Radio of the AP.
Chl(After/Before) Channels
before and after channel optimization.
Date(yyyy-mm-dd)
Date, in the format of yyyy-mm-dd.
Time(hh:mm:ss)
Time, in the format of hh:mm:ss.
Displaying the mesh link status
Mesh link monitoring
1.
Select Wireless Service > Mesh Service from the navigation tree.
2.
Click the Mesh Link Info tab.
Figure 480 Displaying the mesh link monitoring information
You can monitor the mesh link status in real-time on the mesh link monitoring page.
Mesh link test
1.
Select Wireless Service > Mesh Service from the navigation tree.
2.
Click the Mesh Link Test tab.