Enabling spectrum analysis on a radio, Displaying interference device state, Enabling spectrum analysis on a – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 527: Radio
506
Item Description
Trap on Device Types
Configure the AC to send SNMP traps to the NMS when a specified interference
device is detected.
•
To add a device type to the Device Types area, select a device type in the Trap
on Device Types area, and click <<.
•
To remove a device type from the Device Types area, select a device type in this
area, and click >>.
By default, all device types in the Trap on Device Types area are detected.
IMPORTANT:
Before using this function, you must select the target devices in the Devices Types to
Detect area. Otherwise, interference device trap does not take effect.
Enabling spectrum analysis on a radio
1.
Select Radio > Spectrum Analysis from the navigation tree.
2.
Click Radio.
Figure 538 Enabling spectrum analysis
3.
Select the radio for which spectrum analysis is to be enabled.
4.
Click Enable.
Displaying interference device state
1.
Select Radio > Spectrum Analysis from the navigation tree.
2.
Click Interference Info.
You can view the non-802.11 interference devices detected by the AP.