Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 211)

L
Firmware 1.37 - 09/2006 211
9400 HighLine | Parameter setting & configuration
Basic drive functions
Brake control
9.11 Brake control
This basic function is used for wear free control and monitoring of a holding brake which
is connected to the optionally available brake module. As an alternative, the holding brake
can also be controlled and monitored via the digital inputs/outputs.
Intended use
Motor holding brakes are used to stop axes when controller inhibit or pulse inhibit is set.
This is particularly important for unbalanced vertical axes.

Stop!
Basically, holding brakes at Lenze motors are not designed for braking during
operation. The increased wear resulting from braking during operation may lead
to an early destruction of the motor holding brake!

Danger!
Please note that the holding brake is an important element of the safety concept
of the entire machine.
Therefore act with caution when commissioning this part of the system!