9400 highline | parameter setting & configuration – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 435
L
Firmware 1.37 - 09/2006
435
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Drive diagnostics via keypad/bus system
Identification data
The parameters listed in the following table which are entered in the »Engineer«
parameter list and in the keypad in the Identification Controller category, serve to
display the identification data of the controller:
Motor current
Maximum torque
Torque at maximum current
Motor - number of pole pairs
Rotor position
Heatsink temperature
Temperature inside the controller
Motor temperature
Controller load (I x t) during the last 180 seconds
External. 24-V voltage
Thermal motor load (I
2
xt)
Electrolytic capacitor temperature
CPU temperature
Time the controller was enabled (elapsed-hour meter)
Power-up time (power-on time meter)
ENP: detected motor type
Parameters
Display
Firmware version
Firmware product type
Firmware - compile date
HW product types
HW serial numbers
HW descriptions
HW manufacturing data
HW manufacturer
HW countries of origin
HW versions
Program name
Parameters
Display