Dfin (mxi2): z-/z track error [0x00aa0002, Can module (mxi2): bus-off [0x00ac0000, 9400 highline | parameter setting & configuration – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 517
L
Firmware 1.37 - 09/2006
517
9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
DFIN (MXI2): Z-/Z track error [0x00aa0002]
DFIN (MXI2): Enable/lamp control signal error [0x00aa0003]
DFIN (MXI2): Supply cannot be corrected anymore [0x00aa0004]
DFOUT (MXI2): Maximum frequency reached [0x00aa0005]
CAN module (MXI2): Bus-off [0x00ac0000]
Response (Lenze setting printed in bold)
Setting:
C14040
(; Adjustable response)
;
None System fault : Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause
Remedy
Digital frequency extension module in MXI2:
Interruption (open circuit) of the signal cable for track Z.
• Check signal cable for track Z.
• Check encoder.
Response (Lenze setting printed in bold)
Setting:
C14041
(; Adjustable response)
;
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked : Warning ; Information
Cause
Remedy
Digital frequency extension module in MXI2:
Interruption (open circuit) of the signal cable for the
"Enable" signal or no "Enable" signal available.
• Check signal cable for "Enable" signal.
• Check encoder.
Response (Lenze setting printed in bold)
Setting:
C14042
(; Adjustable response)
;
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked : Warning ; Information
Cause
Remedy
Digital frequency extension module in MXI2: The
encoder voltage controlled by the digital frequency input
has reached the voltage limit.
Check encoder.
Response (Lenze setting printed in bold)
Setting:
C14080
(; Adjustable response)
;
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked : Warning ; Information
Cause
Remedy
Digital frequency extension module in MXI2: Limit
frequency at the digital frequency output reached.
• The digital frequency has reached the limit value set
in
C014053
.
Check set limit value.
Response (Lenze setting printed in bold)
Setting:
C14595
(; Adjustable response)
;
None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning : Information
Cause
Remedy
CANopen communication module in MXI2: "Bus-off"
state
• Too many faulty telegrams received.
• Cable defective (e.g. loose contact).
• Two nodes with the same ID.
• Remove fault (e.g. EMC).
• Remove loose contact, screw down adapter.
• Assign different node IDs.