Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 361)

L
Firmware 1.37 - 09/2006 361
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | Brake control
12.3.11 Brake control
[12-38] Basic function "Brake control" (schematic diagram)
O
Tip!
Detailed information on brake control can be found in chapter "Basic drive
functions"  subchapter " Brake control ".
(C 211)
The basic function "Brake control" serves to the wear free
control and monitoring of a holding brake.
In the simplest case, an optionally available brake module
is used.
Alternatively the holding brake can also be controlled and
monitored via the digital inputs/outputs.
M
LS_Brake
Note!
In the Lenze setting the brake control is switched off to reach a safe status after
mains connection.