Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 54)

9400 HighLine | Parameter setting & configuration
Drive interface
Controller commands
54 Firmware 1.37 - 09/2006
L
4.6.2 Status display for device command
C00003 indicates the number and the status of the last executed controller command. The
number of the controller command is indicated in the upper 16 bits and the execution
status in the lower 16 bits.
r The following table lists the most important status messages according to the degree
of probability of their occurrence.
1021 Export parameter to file Export current parameter set to file. z
1030 Format file system Format file system of the memory module. z
1040 Restore file system -
10000 Prepare firmware update z
11000 Restart controller z
Controller command Information Status*
The device command status is displayed in C00003 . Status display for device command
C00003
Bit 16 ... 31 Bit 0 ... 15
Device command executed last Status of the last executed controller command
Bit 0 ... 15 Status Concerns device
command
0x0000 Execution ok. All
0x0001 General fault. All
0x8404 File could not be opened. 201, 202, 203, 204,
301, 302, 303, 304
0x841D Fault while reading out of a file. 201, 202, 203, 204,
301, 302, 303, 304
0x841E Fault while writing into a file. 11,
201, 202, 203, 204,
301, 302, 303, 304
0x841F Invalid file type. 201, 202, 203, 204,
0x8420 Unexpected file end. 201, 202, 203, 204,
301, 302, 303, 304
0x8422 Checksum error 201, 202, 203, 204
0x842B Fault while reading the parameter set partition. 1
0x842C Fault while writing the parameter set partition. 11
0x842E No memory module available. 1, 11
0x8502 Processing of the device command is still active. All
0x9Axx CAN fault 0, 1, 5,
91, 92,
201, 202, 203, 204
0x9B07 Rotor position adjustment cannot be executed because of the wrong
motor type (asynchronous motor).
51
0x9B08 Rotor position adjustment has been aborted. 51
0x9B09 Rotor position adjustment cannot be executed since another
identification is active already.
51
0x9B0A Rotor position adjustment cannot be executed since the V/f-test
mode is active.
51