9400 highline | parameter setting & configuration – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 333
L
Firmware 1.37 - 09/2006
333
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation"
Functions
r
Virtual master with inching, handwheel and reduced speed.
r
Conditioning of the master value (master shaft) with master value scaling, register
generation, stretch factor, reversal of rotation direction, and mark synchronisation via
profile generator.
r
Virtual clutch with emergency stop and basic speed
r
Trimming function via profile generator.
r
Conditioning of the setpoint (machine axis/tool) with setpoint scaling, register
generation, and mark synchronisation via profile generator.
r
Additional operating modes for activating the basic drive functions "Homing", "Manual
jog (inching)" and "Position override function".
r
Support of the basic drive functions "Quick stop" and "Limiter".
r
Following error monitoring.
r
Optional control of a holding brake.