Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 276)

9400 HighLine | Parameter setting & configuration
Standard TAs
TA "Actuator – torque" | Speed limit value conditioning
276 Firmware 1.37 - 09/2006
L
Use of further ramp parameter sets
If required, 15 further ramp parameter sets can be parameterised. For the selection of the
ramp parameter sets1 ... 15 the selection inputs are to be assigned with the corresponding
signals. The selection of the ramp parameter sets is carried out in a binary coded manner.
r Parameter setting: Tab Application parameter Dialog levelOverview  Ramp
generator  All ramp parameters
Parameters Lenze setting
Value Unit
C03512/1 Acceleration time 1 0.000 s
C03512/... Acceleration time ... ... ...
C03512/15 Acceleration time 15 0.000 s
C03513/1 Deceleration time 1 0.000 s
C03513/... Deceleration time ... ... ...
C03513/15 Deceleration time 15 0.000 s
C03514/1 S-ramp time 1 0.000 s
C03514/... S-ramp time ... ...
C03514/15 S-ramp time 15 0.000 s
Control inputs of the function Signal configuration
Lenze setting Control input (Multiplexer parameters)
FALSE  Activate ramp parameter set 1 C03009/8
FALSE  Activate ramp parameter set 2 C03009/9
FALSE  Activate ramp parameter set 4 C03009/10
FALSE  Activate ramp parameter set 8 a C03009/11