Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 534)

9400 HighLine | Parameter setting & configuration
Diagnostics & error analysis
Error messages of the operating system
534 Firmware 1.37 - 09/2006
L
Positive software limit switch has been overtravelled [0x00b80007]
Negative software limit switch has been overtravelled [0x00b80008]
Positive direction of rotation has been limited [0x00b80009]
Negative direction of rotation has been limited [0x00b8000a]
Speed has been limited [0x00b8000b]
Response (Lenze setting printed in bold) Setting: C02716/2 (; Adjustable response)
; None System fault ; Fault ; Trouble : Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The positive software limit position parameterised in
C02702/2 has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Response (Lenze setting printed in bold) Setting: C02716/2 (; Adjustable response)
; None System fault ; Fault ; Trouble : Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The negative software limit position parameterised in
C02702/1 has been overtravelled.
• Position within the software limit positions.
• Increase permissible traversing range (change setting
of the software limit positions).
• Deactivate monitoring of the software limit positions
by the basic function "Limiter".
Response (Lenze setting printed in bold) Setting: C02716/1 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
Due to the setting of C02707 it was tried to traverse in
the impermissible positive direction of rotation.
• Only traverse in permissible (negative) direction of
rotation.
• Change setting of the permissible direction of
rotation ( C02707 ).
Response (Lenze setting printed in bold) Setting: C02716/1 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
Due to the setting of C02707 it was tried to traverse in
the impermissible negative direction of rotation.
• Only traverse in permissible (positive) direction of
rotation.
• Change setting of the permissible direction of
rotation ( C02707 ).
Response (Lenze setting printed in bold) Setting: C02716/3 (; Adjustable response)
: None System fault ; Fault ; Trouble ; Quick stop by trouble ; Warning locked ; Warning ; Information
Cause Remedy
The requested profile speed is higher than the maximum
speed set in C02703 and has been limited to this speed.
• Reduce speed of the traversing profile of the basic
function (manual jog, referencing or positioning).
• Increase maximum speed ( C02703 ).
• Deactivate monitoring of the limit values by the basic
function "Limiter".