12 tas for interconnection via electrical shaft, Tas for interconnection via electrical shaft, 9400 highline | parameter setting & configuration – Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) User Manual
Page 287
L
Firmware 1.37 - 09/2006
287
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
12
TAs for interconnection via electrical shaft
The technology applications described in this chapter are available for a DC-bus operation
of several drives via the electrical shaft.
Technology application/application ranges
Required license/delivery
TA "Electronic gearbox" (C 297)
• Slitters
• Calender drives
• Line drives
• Conveying belts
• Vibrators
• Roller mills
• Stretching machines
• Wire drawing machines
License stage Motion Control
HighLevel or higher required.
The technology application can be
selected in the »Engineer«
application catalog.
TA "Synchronism with mark synchronisation" (C 332)
• Printing units
• Asynchronous cross cutters
• Perforating machines
• Insetters
• Vibrating drives
• Line drives
• Labelling machines
License stage Motion Control
HighLevel or higher required.
The technology application can be
selected in the »Engineer«
application catalog.