Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 363)

L
Firmware 1.37 - 09/2006 363
9400 HighLine | Parameter setting & configuration
TAs for interconnection via electrical shaft
TA "Synchronism with mark synchronisation" | Signal configuration of drive and motor interface
12.3.12 Signal configuration of drive and motor interface
If required, the preset signal configuration of the control and setpoint inputs of the drive
and motor interface can be easily reconfigured per parameter setting of the assigned
multiplexer parameters.
Drive interface
Motor interface
Signal (Lenze setting) Control input Signal configuration
FALSE  Set controller inhibit C03130/1
DigIn 5  Reset error 1 C03130/2
Control word 1 bit 07  Reset error 2 C03130/3
FALSE  Reset error 3 C03130/4
FALSE  Set error C03130/5
Control word 1 bit 00  Switch on drive C03130/6
Signal (Lenze setting) Setpoint input Signal configuration
100 %  Position controller adaption C03141/1
100 %  Phase controller adaption C03141/2
100 %  Adaptation of speed controller C03141/3
100 %  Upper torque limit value C03141/4
-100 %  Lower torque limit value C03141/5
100 %  Flux setpoint C03141/6