Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 565)

L
Firmware 1.37 - 09/2006 565
9400 HighLine | Parameter setting & configuration
Parameter reference
Parameter list | C00211
C00211
C00212
C00213
C00214
C00217
C00218
C00225
C00254
Parameter | Name:
C00211 | Application: Version
Data type: VISIBLE_STRING
Index: 24364
d
= 5F2C
h
; Read access Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00212 | Application: Type code
Data type: VISIBLE_STRING
Index: 24363
d
= 5F2B
h
; Read access Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00213 | Application: Compilation date
Data type: VISIBLE_STRING
Index: 24362
d
= 5F2A
h
; Read access Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00214 | Required safety module
Data type: UNSIGNED_8
Index: 24361
d
= 5F29
h
Setting of the expected safety module
• If a different safety module is detected, an error (trouble) will be activated. The error can only be eliminated by
restarting the controller.
Selection list (Lenze setting printed in bold)
1 SM0
2 SM100
4 SM300
; Read access ; Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00217 | Parameter error information
Data type: UNSIGNED_32
Index: 24358
d
= 5F26
h
This code is used internally by the controller and must not be overwritten by the user!
Parameter | Name:
C00218 | Application: ID number
Data type: UNSIGNED_32
Index: 24357
d
= 5F25
h
Display range (min. value | unit | max. value)
0 0
; Read access Write access CINH PLC STOP No transfer COM MOT
Parameter | Name:
C00225 | Check configuration
Data type: UNSIGNED_32
Index: 24350
d
= 5F1E
h
This code is used internally by the controller and must not be overwritten by the user!
Parameter | Name:
C00254 | Phase controller gain
Data type: UNSIGNED_32
Index: 24321
d
= 5F01
h
Setting range (min. value | unit | max. value) Lenze setting
0.00 1/s 1000.00 20.00 1/s
; Read access ; Write access CINH PLC STOP No transfer COM MOT Scaling factor: 100