Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37) - Manual (Page 212)

9400 HighLine | Parameter setting & configuration
Basic drive functions
Brake control | Parameter setting
212 Firmware 1.37 - 09/2006
L
9.11.1 Parameter setting
r Parameterisation dialog in the »Engineer«: Tab Application parameter  dialog level
Overview  All basic functions  Brake control
r Short overview of parameters for brake control:

Danger!
For a faultless function of the automatic brake system the different delay times
must be set correctly in the following parameters!
If the delay times are set incorrectly, a faulty brake control may be caused!
Parameters Information
C02580 Operating mode - brake
C02581 Brake activation threshold
C02582 Brake resp. to pulse inhibit
C02583 Status input monitoring
C02585 Brake control polarity
C02586 Starting torque 1
C02587 Starting torque 2
C02588 Source of starting torque
C02589 Brake closing time
C02590 Brake opening time
C02591 Waiting time - status monit.
C02593 Waiting time - brake active.
C02594 Test torque
C02595 Permissible angle of rotation
C02596 Grinding speed
C02597 Accel./decel. time - grinding
C02598 Grinding ON time
C02599 Grinding OFF time