H3C Technologies H3C Intelligent Management Center - Manual (Page 240)

226
Using existing SNMP template
To configure the SNMP settings for this device using an SNMP template:
1. Click the radio button to the left of Select an Existing Template.
2. Click the radio button to the left of the template you want to use.
3. Click OK.
4. Do one of the following:
{
To view and configure Telnet settings for this device, click the Telnet Settings link.
{
To configure the Telnet settings for this device, click the Configure link located at the Telnet
Settings section.
The Telnet Parameters dialog box appears.
You can either enter the Telnet settings in this dialog box or select an existing Telnet template that
contains the Telnet settings for this device. Telnet templates are particularly useful when Telnet
configurations are standardized. For more information about creating Telnet templates, see
" Telnet templates ."
Editing Telnet parameters manually
1. To edit the Telnet parameters manually, verify that the radio button to the left of Edit Telnet
Parameters is selected.
2. Do the following:
a. Authentication Mode: Select the mode that matches the Telnet authentication mode configured
on the managed devices from the Authentication Mode list.
b. Username: Enter the username configured on managed devices in the Username field, if
prompted.
c. Password: Enter the password configured on the managed devices in the Password field, if
prompted.
d. Super Password: Enter the super password configured on the managed devices for the Super
Password, if prompted.
e. Timeout: Enter the Telnet timeout value configured on the managed device in the Timeout field.
Valid range is 1–60 seconds.
Using an existing Telnet template
To configure the Telnet settings for this device using Telnet templates:
1. Click the radio button to the left of Select an Existing Template.
2. Click the radio button to the left of the Telnet template you want to use.
3. Click OK.
4. Do one of the following:
To view and configure SSH settings for this device, click the SSH
Settings link.
To configure the Telnet settings for this device, click the Configure link located at the SSH
Settings section.
The SSH Parameters dialog box appears.