H3C Technologies H3C Intelligent Management Center - Manual (Page 392)

378
Checking device access settings in batch mode
Using IMC batch mode operation feature, you can configure plans to check SNMP, Telnet, and SSH
settings and determine quickly whether SNMP, Telnet, or SSH is enabled and functioning on managed
devices from the plan execution and check results in the plan list.
Using batch mode to create a plan to check access settings
To create a plan to verify the access settings for network devices using batch mode:
1. Navigate to Resource > Batch Operation > Check Access Settings:
a. Click the Resource tab from the tabular navigation system on the top.
b. Click Resource Management on the navigation tree on the left.
c. Click Batch Operation under Resource Management from the navigation system on the left.
2. Click the Check Access Settings link from the Check Configuration section of the Resource > Batch
Operation page.
The Check Access Settings window appears.
3. Click Add to select the devices for which you want to check the SNMP, Telnet, or SSH settings.
You can add devices using either the View or Advanced query option. See "
Adding devices by
View " and " Adding devices by Advanced query ."
4. Select the access parameters to be checked, SNMP, Telnet, or SSH.
5. Run the check access settings plan now or schedule it to run once at a later date by selecting from
the following:
• To run the batch mode check access setting plan now, select Immediately from the Schedule
Information list.
• To schedule the plan to run in the future, select Once.
If you selected Once:
a. Enter a date and time in the field next to the Schedule Information.
b. Enter the date and time manually or enter it by clicking the field.
A popup calendar appears.
c. Select the date from the calendar.
To enter it manually, the valid date format is YYYY-MM-DD hh:mm:ss where YYYY refers to the
four-digit year, MM refers two-digit month, DD refers to the two-digit day, hh refers to the
two-digit hour, mm refers to the two-digit minute, and ss refers to the two-digit second values.
6. Click OK.
The check plan appears in the Plan List.
Viewing the plan list
To view the plans for checking the access settings in the plan list:
1. Navigate to Resource > Batch Operation > Check Access Settings > Plan List:
a. Click the Resource tab from the tabular navigation system on the top.
b. Click Resource Management on the navigation tree on the left.
c. Click Batch Operation under Resource Management from the navigation system on the left.
2. Click the Edit Plan link after the Check Access Settings from the Check Configuration section of the
Resource > Batch Operation page.