H3C Technologies H3C Intelligent Management Center - Manual (Page 891)

877
would be a valid entry for a MAC address in IMC.
Similarly, the format for a MAC address mask consists of three sets of four hexadecimal characters
separated by a dash, "-". For example:
ffff-ffff-ffff
would be a valid entry for a MAC address mask in IMC.
The MAC address and its mask must be separated by a forward slash, "/".
A valid entry for a MAC Address/Mask would be
0014-2ad9-05f7/ffff-ffff-ffff
11. Select the destination MAC address option you want to use by clicking the radio button to the
left of the desired option in the Destination Address section.
This option specifies where the pattern matching occurs in this template rule. In this case, the
pattern matching is applied to the destination MAC address.
{
All: Allows you to permit or deny traffic for all MAC addresses, or
{
MAC Address/Mask: Allows you to identify a specific MAC address and its mask for which you
want to either permit or deny traffic.
A valid MAC address format for IMC consists of three sets of four hexadecimal characters
separated by a dash, "-". For example:
0014-2ad9-05f7
would be a valid entry for a MAC address in IMC.
Similarly, the format for a MAC address mask consists of three sets of four hexadecimal characters
separated by a dash, "-". For example:
ffff-ffff-ffff
would be a valid entry for a MAC address mask in IMC.
The MAC address and its mask must be separated by a forward slash, "/".
A valid entry for a MAC Address/Mask would be
0014-2ad9-05f7/ffff-ffff-ffff
12. Select the 802.1 priority you want to apply to this ACL rule from the 802.1 Priority list.
13. Select the Layer 2 encapsulation type you want to apply to this ACL rule from the Encapsulation
Type list.
14. Enter the Source VLAN ID by entering it in the Source VLAN ID field.
This field cannot contain question marks or blank spaces.
15. Select the Layer 2 frame type from the Based Frame Type list.
16. If you selected Ethernet Frame or 802.2 Ethernet Frame in the Base Frame Type list, you must
specify a code in the Code field.
A valid entry for this field includes any four character hexadecimal value.
17. If you selected Ethernet Frame or 802.2 Ethernet Frame in the Base Frame Type list, you must also
specify a mask in the Mask field.
A valid entry for this field includes any four character hexadecimal value.
18. Click OK to create the rule you have just configured.
Adding or modifying a user-defined rule in a user-defined rule set
To add or modify a user-defined rule in a user-defined rule set:
1. Navigate to ACL Resource: