H3C Technologies H3C Intelligent Management Center - Manual (Page 401)

387
4. To configure the port path cost for the selected interfaces, first verify that the checkbox to the left of
the Port Path Cost field is checked.
5. Enter the port path cost in the Port Path Cost field.
The Port Path Cost field must contain an integer that is greater than or equal to zero.
6. To enable spanning tree Fast Start, first verify that the checkbox to the left of the Spanning Tree
Fast Start field is checked.
7. Select Enabled from the Spanning Tree Fast Start list.
8. Run the batch mode save configuration task now or schedule it to run once at a later date by
selecting from the following:
{
To run the batch mode save configuration task now, select Immediately from the Schedule
Information list.
{
To schedule the task to run once in the future, select Once.
If you selected Once:
a. Enter a date and time in the field next to the Schedule Information.
b. Enter the date and time manually or enter it by clicking the field.
A popup calendar appears.
c. Select the date from the calendar. To enter it manually, the valid date format is YYYY-MM-DD
HH:MM:SS where YYYY refers to the four-digit year, MM refers two-digit month, DD refers to
the two-digit day, HH refers to the two-digit hour, MM refers to the two-digit minute, and SS
refers to the two-digit second values.
9. Click OK.
The Plan List displays along with the status of the batch mode operation task in the Status field.
10. Click Refresh to update the Plan List and the Status field.
When the task is complete, the Status field updates to Finished.
11. Click the Details icon associated with the task to view detailed results of the batch mode task.
If you opted to run the batch mode operation at a later date, you can review the results of this batch
operation task by clicking on [Edit Plan] to the right of Configure STP Interface.
Using batch mode to configure LACP
Using batch mode, you can apply Link Aggregation Control Protocol (LACP) configurations to one or
more interfaces. You can also schedule IMC to run the LACP configuration batch operation once.
To configure the LACP on interfaces using batch mode:
1. Navigate to Resource > Batch Operation > Configure LACP.
a. Click the Resource tab from the tabular navigation system on the top.
b. Click Resource Management on the navigation tree on the left.
c. Click Batch Operation under Resource Management from the navigation system on the left.
2. Click the Configure LACP link from the Device Configuration section of the Resource > Batch
Operation page.
3. Click Add to select the device interfaces to apply this batch mode operation to.
You can add devices using either the View or Advanced query option. See "
Adding devices by
View " and " Adding devices by Advanced query ."
4. To enable LACP on the selected devices, select Enabled from the LACP State list.