H3C Technologies H3C Intelligent Management Center - Manual (Page 589)

575
{
If you do not, go directly to Step 32.
31. To configure the SSH settings for this device, click the Configure link located at the SSH
Settings of the Access Parameters section.
The SSH Parameters dialog box appears.
You can either enter the SSH settings in this dialog box or select an existing SSH template that
contains the SSH settings for this device. SSH templates are useful when SSH configurations are
standardized. For more information about creating SSH templates, see "
SSH templates ."
a. Editing SSH settings manually
To edit the SSH parameters, verify that the radio button to the left of Edit SSH Parameters is
selected.
{
Authentication Mode: Select the authentication mode from the Authentication Mode list. The
authentication mode selected must match the configuration on the managed devices.
{
User Name: Enter username in the User Name field.
{
Password: Enter the password in the Password field, if prompted.
{
Private Key File: Enter the path and filename of the private key file that contains the key that
enables login, if prompted.
{
Private Key Password: Enter the private key password for the private key file, if prompted.
{
Port: Enter the TCP port for SSH in the Port field. The default TCP port is 22.
{
Timeout: Enter the SSH timeout value (1–120 seconds). The timeout parameter defines how long
the system waits for the device to respond in seconds before declaring that the response has
timed out. The default setting is 10 seconds.
{
Retries: Enter the number of SSH retries (1–5). The retries parameter defines how many times the
management system (IMC) sends SSH retries in an attempt to communicate with the managed
device before reporting a failure. The default setting is 3.
b. Using existing SSH templates
c. Click the radio button to the left of Select an Existing Template.
d. Click the radio button to the left of the SSH template you want to use.
e. Click OK to apply the SSH configuration settings to this device.
32. Click OK to apply this device configuration.
Review the results of the add operation in the Auto Deployment Plan page.
Modifying an automatic deployment device
To modify an existing automatic deployment device:
1. Navigate to Service > Auto Deployment Plan.
a. Click the Service tab from the tabular navigation system on the top.
b. Click the Configuration Center on the navigation tree on the left.
c. Click the Auto Deployment Plan under Configuration Center from the navigation system on the
left.
All existing automatic deployment plans are displayed in the Auto Deployment Plan page.
2. Click the icon with the deployment plan you want to expand.
All existing devices in the deployment plan appear.
3. Click the icon in the Operation field associated with the deployment device you want to
modify.