H3C Technologies H3C Intelligent Management Center User Manual
Page 741
727
•
All Devices: If you select this option after initially configuring this option with Selected Devices, then
IMC overrides the existing configuration by configuring the alarm rule to send to all devices.
•
Selected Devices: With this option, only the selected devices trigger alarm forwarding if the alarm
condition meets the rule's Concerned Alarm Level setting.
You can modify your selection devices by Device IP address, by Custom Views, by Network
Segment or by a combination of the three. For more information, see "
", "
Selecting devices by custom view
Selecting devices by network segment
."
You can also select devices by using Select located to the right of the Device IP field. This
enables you to use IMC display and search capabilities to select the device(s) from established
groups and views either By View or by query using the Advanced feature. See "
" and "
Adding devices by Advanced query
7.
Modify which error conditions trigger alarm forwarding from the Concerned Alarms list. Operators
can select all conditions or only a specified subset of conditions that trigger alarm forwarding.
•
All Alarms: With this option, all alarms configured in IMC trigger alarm forwarding if the alarm
condition is triggered.
•
Selected Alarms: With this option, only the alarms you select in alarm notification trigger alarm
forwarding if the alarm condition is triggered. If you choose Selected Alarms, you can choose
which alarm conditions trigger alarm forwarding.
8.
Click Select to configure which conditions to alarm on.
9.
In the Select Alarm dialog box, locate the Enterprise MIB that contains an object or condition that
you want to alarm on.
10.
To expand your view of the MIB, click the arrow key next to the MIB that contains an object or
condition that you want to alarm on.
11.
Do one of the following:
{
Click the Expand all icon located in the upper right corner of the Select Alarm dialog box to
expand your view to display all MIB, or
{
Use the query function located at the top of the Select Alarm dialog box to locate the object that
you want alarm on by entering one or more of the following search criteria:
−
Trap Name: Enter the object name for the trap you want to locate in the Trap Name field.
−
Trap OID: Enter the Object ID for the trap in the Trap OID field.
−
Enterprise Name: Enter a partial or complete name for the Enterprise MIB you want to
locate in the Enterprise Name field.
−
Enterprise OID: Enter a partial or complete Enterprise ID for the MIB you want to locate in
the Enterprise OID field.
{
Click Query to submit your search criteria.
The results of your query displayed in the dialog box.
Click Reset to clear your query criteria and to restore the full list of MIBs and traps.
12.
Click the checkbox to select a MIB object that you want to add to this alarm rule.
13.
Click OK.
It may take a while for the Select Alarm dialog box to close. When the box closes, it updates the
Concerned Alarms field with the configured object or alarm condition.
14.
Click multiple checkboxes to select multiple objects or conditions to alarm on. Each alarm
condition is listed in the Concerned Alarms field below the list.