H3C Technologies H3C Intelligent Management Center - Manual (Page 469)

455
c. Click Virtual Network View under Virtual Resource Management from the navigation tree on
the left. The Virtual Network View is displayed in the main portion of the Virtual Resource
Management page.
2. Click the Resource Name or the IP Address link of the server for which you want to add vSwitch.
The Server Details page appears.
3. Click on the Add vSwitch link located in the upper right corner of the Server Details page.
The Add vSwitch page appears.
4. Enter the name of the vSwitch.
5. Use the scrolling bar to select Number of the Ports, which ranges from 1 to 1016.
6. Select one or more Physical Network Cards.
7. Highlight the network cards you want to select and click on the Select button.
8. To select all of the physical network cards displayed in the Physical Network Card list, click the
Select All button.
9. Do one of the following:
To remove one or more, select them and click Remove, or
To remove all of the selected devices, click Remove all.
10. Confirm that the physics network cards you have found have been added.
11. Click OK.
Adding port group
To add a port group to a server:
1. Navigate to Resource > Virtual Network View.
a. Click the Resource tab from the tabular navigation system on the top.
b. Click the Virtual Resource Management section of the navigation tree on the left.
c. Click Virtual Network View under Virtual Resource Management from the navigation tree on
the left. The Virtual Network View is displayed in the main portion of the Virtual Resource
Management page.
2. Click the Resource Name or the IP Address link of the server for which you want to add port group.
The Server Details page appears.
3. Click the Add Port Group link located in the upper right corner of the Server Details page.
The Add Port Group page appears.
4. Select a type of port group from the Type list.
5. Enter the name of the port group in the Name field.
6. Enter the VLAN ID in the VLAN ID field.
7. Select a vSwitch from the vSwitch list.
8. Enter the IP Address of the network card that binds to the vSwitch.
If you select VMkernel in Step4, this option is required.
9. Enter the Mask of the IP address in the Mask field.
If you select VMkernel in Step4, this option is required.
10. Click OK.
Refreshing a server details page
To refresh the Server Details page: