Interface management – H3C Technologies H3C Intelligent Management Center User Manual
Page 383
369
DOWN
From the Interface Details page, you can change the management status of the selected interface to
DOWN.
1.
Click the DOWN link located under the Action section of the right navigation tree on the selected
interface's Interface Details page.
The top of the Interface Details page updates to reflect the completion status of the task.
User-Defined Speed
From the Interface Details page, you can change the user-defined speed setting for the selected interface.
1.
Click the User-Defined Speed link located under the Action section of the right navigation tree on
the selected interface's Interface Details page.
2.
Enter the speed you want to assign to this interface in the User-Defined Speed field.
3.
Select the unit of speed measurement from the list located to the right User-Defined Speed field.
4.
Click OK.
If you leave the User-defined Speed field blank, the value of N/A is applied.
The top of the Interface Details page updates to reflect the completion status of the task. In addition,
the User-Defined Speed field updates to include the configuration change.
Up/Down Alarm Filter
From the Interface Details page, you can change the Up/Down Alarm Filter status of the selected
interface.
1.
Click the Up/Down Alarm Filter link located under the Action section of the right navigation tree on
the selected interface's Interface Details page.
The Interface Up/Down Alarm Filter page appears.
2.
Select the status of up/down alarm filter you want to perform from the Interface Up/Down Alarm
Filter list.
For more information about the System Settings, see "
."
3.
Click OK.
IP/MAC Learning Query
From the Interface Details page, you can query the IP/MAC learning for the selected interface.
For information on IP/MAC Learning Query, see "
Interface management
The Interface Management menu options enable you to apply management and configuration options to
the selected interface from the convenience of the navigation tree located on the right of the Interface
Details section. Options under Interface Management include loopback testing, Interface IP
Management, viewing port information and configuring ports, and adding ports to VLANs. The menu
options available for Interface Management vary by device and interface type.
Loopback testing
From the Interface Details page, you can test the loopback interface for the selected device.
1.
Click the Loopback Testing link located under the Interface Management section of the right
navigation tree on the selected interface's Interface Details page.
2.
Click the Port Loopback Test tab located at the top of the Loopback Test window.