H3C Technologies H3C Intelligent Management Center - Manual (Page 251)

237
1. Once you have created the import file, click Import located to the right of the Configured Segment
Address list.
2. Click Browse to locate your import file.
3. Click OK to accept the selected import file.
4. Confirm that the entries in your import file have been added to the Configured Segment Address
list.
Login Type: This option defines how IMC logs into the discovered device.
Options include Telnet, SSH, and None. Select login type from the Login Type list. The discovered
devices must be configured to support the login type you select.
5. Use the loopback address as the management IP: If you want IMC to use the Loopback address for
the management of the discovered device, click the checkbox to the left of Loopback Address as
Manager IP.
6. Discover Non-SNMP Devices: IMC can manage devices that do not support SNMP. If you want
IMC to manage these devices, click the checkbox to the left of Discover Non-SNMP Devices.
7. Scan one by one in the Segment: This option configures IMC to discover every device in the
configured network segment. This is a very time consuming option for auto discovery as IMC pings
every IP address in the segment serially and then add the devices that respond to the ping request.
If you want this auto discovery option, click the checkbox to the left of Scan one by one in the
Segment.
8. Automatically register to receive SNMP traps from supported devices: If you want IMC to receive
and process traps from discovered devices, verify that the checkbox to the left of Automatically
register to receive SNMP traps from supported devices is checked .
IMPORTANT:
If the Automatically register to receive SNMP traps from supported devices checkbox is not checked,
IMC does not process, display, or alarm on traps sent by the discovered devices.
9. Perform the left operations in the same way Advanced auto discovery is configured: routing-based,
ARP-based(ND), or IPsec VPN-based, PPP-based. For more information, see "
Advanced auto
discovery: routing-based, ARP-based(ND), or IPsec VPN-based, PPP-based ."
Viewing auto discovery results
To view auto discovery results:
1. Navigate to Resource > Auto Discovery:
a. Click the Resource tab from the tabular navigation system on the top.
b. Click Resource Management on the navigation tree on the left.
c. Click Auto Discovery under Resource Management from the navigation system on the left.
2. Confirm that you are in Basic mode.
The main section of the page title should read Auto Discovery (Basic).
If the dialog box does not have this title and your breadcrumb trail is Resource > Auto Discovery
(Advanced), then click
Go to Basic to navigate to the Auto Discovery (Basic) page. Go to
Basic can be found in the far right corner of the Auto Discovery page.
3. Click Latest Result on the right of the page to enter the auto discovery result page. By default,
the result of the last auto discovery is displayed. For more information about the auto discovery
result page, see " Viewing auto discovery results ."